Head Controls widget
|This control will only be shown if the head of the connected robot can move.|
This control has been designed to move the head of the robot around.
Toggle between analog and digital controls
Move the head
Toggle fixed/temporary position
Tap the icon to switch between the digital and analog controls.
|Not all movements are available on all robots. For example, the head of a (custom) James can only move up or down.|
Use the main controls to move the head.
|Not all digital controls may move the head of the robot. Some robot will only respond to moving up and down for instance.|
Tap + hold an icon to move the head of the robot in the specified direction.
Tap the stop button in the center of the control to reset the head of the robot to the default position.
|The controls are as seen from the robot. This implies that left will turn the head counter-clockwise, while right will turn the head clockwise.|
The analog control uses the same principle as a joystick-controller. Move the inner circle from of the middle to the edge to make the head of the robot move. The further away from the center of the inner circle, the faster the head will move.
To move the head of the robot up or down, simply tilt the control to the top or bottom half of the control to move the head.
|Not all movements are available for all robot-types. For example, the head of a (custom) James can only move up or down.|
The head of the robot can remain in place ( ) after the movement or return to the center-position ( ). In the top-right corner of the control, an (un-)lock-icon is shown. This icon indicates if the head will be locked in place after the movement, or if the head will return to the default (center) position.
Tap the lock-icon to toggle whether the head should remain in the new position after moving it or return to the default position.
|Changing from a locked to unlocked state will reset the robot’s head position back to the default position (usually dead centre).|